溶剂热法制备Ag/TiO2纳米材料及其光催化性能

以乙醇为溶剂, 钛酸四丁酯为前驱体, 用溶剂热法制备了Ag表面修饰的负载型纳米二氧化钛光催化剂. 利用X射线衍射(XRD)、N₂吸附-脱附(BET)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外-可见(UV-Vis)光谱等技术对其进行了系统的表征, 以亚甲基蓝(MB)溶液的脱色降解为模型反应, 考察了不同Ag含量样品的光催化性能. 结果表明: 用溶剂热法制备的样品中TiO₂皆为锐钛矿相, 金属Ag颗粒沉积在TiO₂表面, 粒径为2 nm左右, 比表面积较溶胶凝胶法制备的样品大大增加, 最高可达151.44 m²·g^-1; UV-Vis光谱和光催化实验表明: Ag修饰使TiO₂对光的吸收能力大大增强, 吸收带边红移至可见光区, 亚甲基蓝在该复合材料上的光催化降解反应遵循一级反应动力学模型; 溶剂热法制备样品的光催化性能明显好于溶胶凝胶法制备的样品, 在紫外光和可见光下, Ag摩尔分数为5%的样品表现出最佳的光催化活性.     

MORPHOLOGICAL STUDIES ON THERMOTROPIC LIQUID CRYSTALLINE POLYESTER——MORPHOLOGY OF SHEAR ORIENTED FILMS

The morphology of shear-oriented films of a thermotropic liquid crystalline polyester containing a triad ester mesogenic unit and a flexible spacer has been investigated in details. The formation conditions and process, the fine structures and the relaxation process of mat structure in the oriented films have been observed and discussed.     

逐步增长聚合的研究进展

逐步增长聚合应用面广,且聚合物分子量是逐步增加的,近来利用逐步增长聚合可以合成新型高分子材料日益引人注目。按照逐步增长聚合的不同类型,对近年来逐步增长聚合研究的新进展,特别是对合成聚酯等的缩聚反应,以及利用二异氰酸酯和Click反应的逐步加成聚合等进行了综述。为了进一步获得性能优良、分子量可控、结构理想且制备方法简便的高分子材料,加强逐步增长聚合理论研究、开发新型结构的单体,并充分开发相应的聚合新技术,是今后逐步增长聚合研究的重点。     

等离子体电极普克尔盒研究进展

等离子体电极普克尔盒(PEPC)用作多程放大控制、自激振荡抑制以及反激光隔离,是大型高功率固体激光器的核心器件。本文从高功率固体激光器的发展对光开关提出的要求出发,系统地综述了等离子体电极普克尔盒的性能特点以及研究进展。重点介绍了中国工程物理研究院激光聚变研究中心近年来在PEPC研究方面所取得的进展,包括单脉冲驱动的组合口径PEPC、低损耗PEPC以及重复频率运转的PEPC。     

An efficient,scalable approach to hydrolyze flavonoid glucuronides via activation of glycoside bond

Hydrolyzing flavonoid glucuronides into corresponding aglycones posed some significant challenges. To improve acid-catalyzed hydrolysis process of flavonoid glucuronide, structures of glucuronide, hydrolysis parameters and post-processing were optimized. The optimized condition was performed by hydrolysis flavonoid glycoside methyl ester in a mixed solvent consisting of 2 mol/L H₂SO₄/EtOH/H₂O (1/8/1, v/v/v) at 95 °C for 7 h and resulted in up to 90% aglycone yields, minimal byproduct formations and milder hydrolysis conditions. Furthermore, the optimized method avoids tedious purification steps and is easily conducted on a relatively large-scale using economical and commercially available reagents.     

Study on prediction of noise produced by stern wake-duct-propeller interaction

The mechanism and prediction methods of low-frequency discrete spectrmu noise of ducted propellers are studied. The acoustic pressure field of ducted propellers is divided into the propeller radiated field and the duct scattered field based on the linear acoustic theory. First of all, the flow field is analyzed with unsteady panel method to get the unsteady force, and then the pressure data are used as the sources for Ffowcs Williams-Hawings formulation to predict the propeller radiated field, meanwhile, the duct scattered field is obtained by Kirchoff integral equation. Through the analysis and calculation of a ducted propeller case, it is found that the duct scattered sound field is a small quantity compared with propeller radiated sound field under low-frequency and short duct condition; Also the predicted discrete spectrum noise level of ducted propellers is compared with that of full-scale propellers by experiment, verifying the predicted results are able to reflect the full-scale propellers＇ discrete spectrum noise level properly.     

高精度中小11径非球面修抛技术研究

为实现高精度中小口径非球面的加工，介绍了一种非球面修抛技术。基于Preston假设，将抛光过程描述成一个线性方程，计算得到材料的去除量与抛光时间、抛光压力和零件转速之间的函数关系。设计了整体修抛法和环带修抛法两种方法，在数控抛光的基础上，对口径为Ф117mm的凹抛物面和口径为Ф17mm凸双曲面进行修抛，修抛后非球面的面形精度PV值为0．184μm，RMS均小于0．032μm，达到了工程化应用要求，实现了中小口径非球面的高精度加工。     

“变色冰火球”趣味实验的设计过程与思考

用乙酸钙、酒精和酚酞设计成"变色冰火球"趣味实验。介绍了该实验的设计缘由以及实验的原理、操作方法等,并探讨了"冰火球"变色的一些原因。最后,对中学化学实验教学提出了几点思考。     

富锂层状正极材料Li2Mn1-xTixO3的合成及电化学性能

应用简单的高温固相烧结法合成了Ti掺杂改性的Li₂MnO₃材料。电子扫描显微镜、X射线衍射以及X射线光电子能谱分析表明Ti元素取代Mn离子掺入到Li₂MnO₃晶格中,且掺杂能有效地抑制一次颗粒的团聚。电化学阻抗和恒流充放电测试结果表明,在2.0~4.6 V的电压窗口下,掺杂改性的样品Li₂Mn_0.9Ti_0.03O₃的首圈放电比容量达到209 mAh·g^-1,库仑效率为99.5%,循环40圈后容量保持率为94%;当电流密度增大到400 mA·g^-1时,掺杂改性的样品仍然可以放出120 mAh·g^-1比容量,远高于同等电流密度下未掺杂的Li₂MnO₃原粉的比容量（52 mAh·g^-1）。Ti掺杂可有效地改善Li₂MnO₃的循环稳定性和倍率性能,有利于促进该材料的商业化应用。